Electric bicycle industry, generally refers to the electrical motor assembly, including electrical heart, slow organizations. The following are talking about the electric bike motor means the motor assembly. First, remove the motor
Dismantling the motor before the motor and controller should first unplug the wire, then be sure to record the electrical lead wire color and the color of the correspondence between the controller.
Open the motor cover should be clean as a venue before, in order to prevent debris being sucked inside the magnet on the motor. Wheel well cover and the relative position of the mark. Note: Be sure to loosen the screw on the corner, so the motor casing.
Rotor and stator air gap is called the radial clearance (air gap), usually the motor air gap between the 0.25-0.8mm, when the demolition excluded bike motor complete motor failure, be sure to mark the original cover for assembly This can prevent the sweep chamber after the second assembly of the phenomenon.
Second, the motor gear lubrication
If there is brush and brushless motor have a gear wheel hub motor gear noise began to become larger, or replace the motor in gear, all the gear tooth surface should be painted with grease, grease or 3 general use specified by the manufacturer lubricants.
Third, the motor assembly
In assembling the brush motor, check the flexibility of the spring inside the brush holder, carbon brush and brush holder check whether there is grazing, check the carbon brushes in the brush where it can hold the maximum travel, pay attention to carbon brushes and commutator of the correct positioning of the to avoid carbon brushes or brush card bad grip.
When installing the motor, motor parts should first clean the surface of the impurities, so as not to affect the normal operation of the motor, and a certain firm fixed to the hub body, so as not to install due to the powerful magnet to attract, causing parts hit each other, damage.