bldc motor winding open circuit the motor does not start, three-phase current imbalance, abnormal noise or vibration, temperature exceed the allowable value or smoke.
Winding open circuit due to poor welding or the use of corrosive fluxes, welding and then not cleaned, it may cause solder pot or loose; by mechanical stress or collision coil short-circuit, short circuit and ground fault also can lead burning, and burning in of a few wires in a short circuit or a few wires, the other a few wires as current as temperature rises, causing fever and winding circuit. Generally divided into disconnected end of one phase winding, inter-turn short circuit, parallel circuit branch office, multi-wire and burned in an open circuit, broken rotor cage.
hub motor short circuit causes:
1, when in the repair and maintenance problems touched off or manufacturing quality.
2, the winding of the components, pole (phase) winding and the lead group and the first welding wire and other wire bad, long-running hot sealing off.
3, by mechanical force and electromagnetic force or pull off the winding damage.
4, short circuit and the ground turns white sometimes cause severe burning or winding fuse and so on.
hub motor short-circuit approach:
1, open circuit at the end, the connection is completed weld, wrapped in insulating material, put pipe insulation, banding is good, and then dried.
2, as inter-turn winding, white short-circuit and ground and other reasons caused serious burnt windings should generally be replaced with new winding.
3, the open circuit point in the tank, is a small break to do emergency treatment, the use of groups out method to identify breakpoints and the Ministry of winding down its connected and insulated qualified to use. If your business is a buy and sell or something, you might need motors can be risky and dangerous.
4, the cage can be broken rotor cage welding, cold-connection of a repair or exchange.