We are looking to source some hub motor for a US based e-scooter project.

This one is a prototype but we hope to be in limited production later this year or early next.Each scooter will use two hub motors.

The hub motor needs approximately the following peak spec’s:
Work Voltage:36-48V nominal
Motor Speed:500 rpm at nominal voltage
Power:700-1000W steady state
Full axle (i.e. mountable on both ends)
DC Brushed or Brushless Permanent Magnet
160mm max width

Several of your hub motors seem to be pretty close to this.

From your website:
HBl — turns ~300rpm at 36V. Extrapolating out from the speed constant,at 48V this winding would do about 400rpm. This might be okay but do you have a winding with a higher speed constant?

It looks like the HBL-16″ is the same hub motor with a rim already mounted. This would be of interest.

Please let me know if I can buy 2-4 of these, and how fast I could get them in the United States. Do you have a dealer that stocks them in the US or do you ship direct from China?

Answer:Our 48V 1000W hbl hub motor is fit for your order.Standard 26″ 48V 1000W hub motor wheel reaches 26.7m/h.If need faster speed hub motor. We can customise motor speed.

We suggest you choose 16″ 48V 1000W rear hub motor.It’s 135mm width and
fit for 135mm fork.There are two screw threats on each side cover that are used to install disk brake and 6-sprocket.We re-change the gauge of the coil wires and/or the turns number of the coils,the fastest speed can reach more than 700rpm.

About motor drawings,please visit or download from https://www.leafmotor.com
We can ship 2-4 sets of samples to you by EMS.It takes about 3-7 days to deliver.

Thanks for you are interested in our hub motor.