It took a little work since spacing was tight, but I get the hub motor wheel inside of my forks. When I went to put the nuts on the axle, I saw that the bolt on the wired side is cracked. It is missing almost all of its thread which means I cannot but the nut on to hold the wheel in place. Essentially, I cannot use it at all. Please see the picture of the cracked bolt.
I was wondering if you know how I am able to repair this hub motor ‘s shaft or if I can somehow get some help on this? I spent a lot to get it all here and it is a little upsetting that a small chip is preventing me from using it at all. I’m not asking for a whole new electric hub motor wheel to be sent, just hoping I can get this bike conversion kit up and hub motor running. Please advise.
If possible, add some washers,then can solve it.
Do it as below:
Disconnect that white big plug,then can take off screw nut and add some washers into.
*. Look for a pin
*. There are five wires in this white big plug
*. Press each wire’ s pin, then the pin will out of white big plug.
I had thought I got bike conversion kit to work but there just is not enough room to to secure the nut properly. Please let me know what will be the best way to have this resolved. Sorry for the inconvenience on this.
Add washer or torque arm or lock washer.
Comments are closed.