Leafmotor

First question: do you already have 1500W front hub motor for disk brake?
What is dropout width? If still no front disk brake version, please find order below.

We need 20 of these torque plates in our order.
Please send us:
1. part number of torque plate
2. dimensions/drawing of torque plate (thickness, length, hole shape,…)
3. cost of torque plate
I will adjust purchase order with this information.
Also, I requested side cover painted black.

We can make one kind of 1500w front hub motor with disk. (Have all motor parts in stock)
It’s nearly the same to below picture and drawing.(The cable comes from shaft end.. But ONLY max use 2mm high temp phase wires)2mm high temp phase wires is also fit for 1500W.

First question: we don’t have 1500w front hub motor for disk.. ( The reason is 1500w is thick, even use disk brake cover, still no room to install disk on it for 100mm dropout.What’s the dropout of your fork?

Dropout is 100mm. For future production, we can increase dropout width:
– this order we will do without disk brake

We found we can’t supply all black color cover in short time.
The reason is:
* This 1500w front motor use 3mm phase wire
* cable should comes center of shaft (Not from shaft end, if shaft end,max use 2mm)
* So must use that kind of black with silver cover.(last sample)
* we have this black with silver cover in stock. (last sample)
* If re-paint this black with silver cover be all black,may not good look.
* If re-make six cover should wait long time until used out this black with silver cover.

Re-paint black is faster.

Please repaint black with silver cover to full black (black with silver is not acceptable for European customer). What is additional lead time for painting of stock covers?For next year, we can discuss proper solution with on time ordering.Also, can you please look into my questions about CAD?For this development, please send us CAD design (STEP file) of 1500W motor with

– 3mm phase cable in between dropouts
– 34mm wide body
– new shaft (14 or 16mm?)
– final drop out width (110mm? 115mm?)

Please keep order as before:
– black side covers
– no disk brake

We will do disk brake as a separate development with:
– new fork design
– proper disk caliper integration
– 3mm wire inside drop out
– torque arm integration into fork
– 3mm phase cable in between dropouts
– 34mm wide body
– new shaft (14 or 16mm?)
– final drop out width (110mm? 115mm?)