Q: Now that I understand the purpose of these wires, I need to know exactly how to connect bike conversion kit wires.
1. “you could use a switch(on/off)to short pink and black”
1.1 What kind of switch? Is it included this bike kit or I have to buy it?
1.2 If I have to buy a switch, what are the characteristics of it? How do I connect pink/black wires to the switch?
1.3 If so, do I need to buy additional wires to connect pink/black to the switch? If so – what are the characteristics of it, wire resistance/diameter?
1.4 These pink/black wires are connected to a plastic connector
Do I need to buy another connector to connect my new hub motor ?

2 “use yellow and brown wires coming from the throttle to control your bike kit cruise.”
2.1 Again-how would I do that? Do I need to connect yellow/brown wires somewhere on the hub motor controller, is so – how?
2.2 Please note that these wires don’t have any kind of connector attached – am I suppose to connect them ?

3 “put the green wire to “+” and the grey to “-“, your LED on your throttle will light”
3.1 Where are the “+” and “-” you are referring to? Is it on the battery itself, or controller, or elsewhere? (for example: battery itself doesn’t seem to have open +/- sockets – other than the one used by the supplied cable)
3.2 Can I connect green/grey permanently (so that LED always shows the battery status), if so – how would I connect? Where would I connect them to exactly – controller or battery?
3.3 Again please note that green/grey wires are not attached
to any connector, just “bare” wires, so I don’t understand how can I connect them?
If you have any additional photographs and/or drawings, please share them also. If I need to buy
additional parts – please let me know what they are.

A: Don’t mistake with the positive and cathode of your bike kit battery to hub motor controller.(red and black battery wires).It doesn’t matter about making a mistake with other wires.
Don’t worry. Short any thin wires, it doesn’t burn your controller.
1.Cruise: when your motor is running, connect the pink wire to black wire(use a wire to connect pink and black wire) or you could use your brake lever to test this function. When your brake, it will cruise, when your loose your brake level, it will cancel cruise function.
2.This switch just have on/off function, you could buy other switches in your market
3.You should use a wire to connect bike conversion kit, it doesn’t matter about wire resistance / diameter, is this wire, no current.
4.You could use spare connector: yellow connect pink wire, brown connect black wire (C&Z),when your motor is running, press this red switch, your motor will cruise as the same speed.
Put the green wire to battery “+”
Put the grey wire to battery “-”
The Led will light, try it as I said, it doesn’t burn anything.
In fact, it’s very easy to do it, for example, you could use your
handle brake (two wires) to make a female connector connect any connector (white & black, pink & black)from hub motor controller.
If possible, you could use a software “e-drawing” to open our 3D about this hub motor controller.